![asme y14.5 standard drawings format asme y14.5 standard drawings format](https://i0.wp.com/www.fcsuper.com/swblog/wp-content/uploads/2011/02/PatternDim71.jpg)
Fundamental to the current content and maintenance of MIL-STD-100 is the existence of theDOD/Industry Drawing Practices Group (DRPRG). An accurate perception of DoDEngineering Drawing Practices therefore necessitates user recognition of MIL-STD-100G,ASME Y14.24M, ASME Y14.34M, ASME Y14.35M, and ASME Y14.100M as being acomposite set.Ħ. Accordingly, this standard will be revisedperiodically to take advantage of those non-Government standards which meet the DoD criterionfor technical sufficiency.Similarly, and in keeping with the DoD practice of adopting non-Government standardswhenever practicable, Chapters 600 and 700, as contained in previous versions of MIL-STD-100, have been entirely replaced by ASME Y14.35M and ASME Y14.34M respectively, andChapter 200 is largely based on ASME Y14.24M. The policy of the DoD is to utilize to the maximum degree possible those non-Governmentstandards which satisfy the needs of the military. Locations for Marking on engineering drawings.ĥ. Numbering, coding and identification procedures for engineering drawings, associated listsand documents referenced on these engineering drawings and associated lists.Į. Procedures for the creation of titles for engineering drawings.ĭ. Requirements for drawings derived from or maintained by Computer Aided Design (CAD).Ĭ. Standard practices for the preparation of engineering drawings, drawing format and media fordelivery.ī. The applicable end item requires Government logistics supportĪ. It is required and fully justifiable that a DoD activity be the design activity Thecontractual application of MIL-STD-100 is permissible provided one or both of the followingconditions exist:
![asme y14.5 standard drawings format asme y14.5 standard drawings format](https://krulikowskiconsulting.com/wp-content/uploads/2017/07/Item-3-bracket.jpg)
The preferred standard for Engineering Drawing Practices is ASME Y14.100M. Army ArmamentResearch, Development and Engineering Center, ATTN: AMSTA-AR-EDE-S, Picatinny Arsenal,NJ 07806-5000, by using the Standardization Document Improvement Proposal (DD Form 1426)appearing at the end of this document or by letter.ģ. Beneficial comments (recommendations, additions, deletions) and any pertinent data which maybe of use in improving this document should be addressed to: Commander, U.S. This Military Standard is approved for use by all Departments and Agencies of the Departmentof Defense (DoD).Ģ. Source: - Downloaded: T15:23ZCheck the source to verify that this is the current version before use.ġ. Approved for public release distribution is unlimited. MIL-STD-100G 9 JUNE 1997 SUPERSEDING MIL-STD-100F 9 SEPTEMBER 1996ĪMSC N/A AREA DRPRDISTRIBUTION STATEMENT A.